ENGLISH
SINBO SFH 3369 FAN HEATER
INSTRUCTION MANUAL
AC230V, 50Hz, 2000W
FOR YOUR OWN SAFETY
1. Read all instructions before using the fan heater.
2. Only connect the fan heater to a single-phase socket with a main voltage as specified on the rating
plate.
3. This appliance meets the electromagnetic compatibility requirements specified in BN 55104/95 with
regard to interference with radio and TV sets.
4. Do not leave your home while the appliance is in function: ensure that the switch is in OFF(0) position
and the thermostat is in minimum position. Always unplug the appliance.
5. Keep combustible material such as furniture, cushions, bedding, paper, clothes, curtains etc. at least
100cm away from the fan heater.
6. If wall mounted do not fix to combustible material such as wooden, synthetic or plastic surfaces. Do
not hang anything on or in front of the fan heater.
7. Always unplug the heater when not in use. Dot not pull the cord to unplug the heater.
8. Keep the air inlet and outlet free from objects: at least 1 m in front and 50 cm behind the heater.
9. Do not install the heater right below a socket.
10. Do not let animals or children touch or play with the fan heater. Pay attention! The air outlet gets
hot during operation (more than 80?, or 175 F ).
11. WARNING: In order to avoid overheating, do not cover the heater.
12. Do not use this fan heater in the immediate surroundings of a bath, a shower or a swimming pool.
13. Do not use the fan heater in the rooms with explosive gas or while using inflammable solvents,
varnish or glue.
14. If the power cord is damaged it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
15. Keep the fan heater clean. Do not allow any objects to enter any ventilation or exhaust opening as
this may cause electric shock, or fire or damage to the heater.
INSTALLATION
The appliance requires no installation, it should be used solely as a portable appliance.
Portable appliances are not suitable for use in a bathroom.
OPERATION
- Turn the thermostat knob in a clockwise direction until it reaches the maximum setting.
- Summer service (ventilation only): Turn the knob to setting
- Heating at reduced power: Turn the knob to setting (1000W).
- Heating at full power: Turn the knob to setting (2000W).
- Switching off: Turn the knob to setting O.
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat knob (where included)
in an anti-clockwise direction up to the point where the appliance switches off and not beyond. The
temperature fixed in this way will be automatically regulated and kept at a constant level by the
thermostat.
IMPORTANT SAFETY FEATURES
This heater is equipped with an AUTOMATIC OVERHEAT SAFETY DEVICE that will turn off the power to
- 4 -