Worx Professional WU281 Manual Original página 7

Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries, Return exhausted
batteries to your local collection or recycling point.
Li-Ion Li-Ion
Do not burn
Do not expose to rain or water
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.
All manuals and user guides at all-guides.com
A)
B)
C)
7
Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTENDED USE
This tool is intended for the fastening and loosening of bolts, nuts and
various threaded fasteners. This tool is not intended for use as a drill.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the Battery Pack (5)
may become too hot to permit charging. Allow time for the battery
to cool down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the Battery Pack Release Button(8) firmly first and then
slide the Battery Pack out from your tool.
TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged Battery Pack onto the tool with sufficient
force until it clicks into position.