Denver TCD-32 Manual Del Usuario página 3

1
5
1
2 3
4
10 11 12 13 14
9
15
16
EN-3
All manuals and user guides at all-guides.com
6 7 8
17
8 x R14 UM-2 C-CELL
• •
English CONTROLS
Top and front panels (See 1. )
1. STEREO HEADPHONE JACK
- 3.5mm ster eo headphone jack
2. VOLUME
- adjusts volume level.
3. FUNCTION SELECTOR
- selects the function CD, TAPE(OFF) or FM
4. DBBS (Dynamic Bass Boost)
- enhances bass response.
5. CASSETTE RECORDER KEYS
RECORD - starts recording.
PLAY - starts playback.
F.FWD/REW - fast winds / rewinds the tape
STOP/EJECT - stops the tape;
- opens the cassette compartment.
PAUSE - interrupts recording or playback.
6
. CD DOOR
- open or close the CD door.
7. HANDLE
- carrying the device
8. TUNING CONTROL
- select the FM station.
9. DISPLAY
- shows the CD functions.
10. PROG.
CD - programs and reviews programmed
track numbers.
11. REREAT
- repeats a track/CD.
12. SKIP / , /
CD: - skips track backwards or forward.
13. STOP
- stops CD playback,
- Delete program playback.
14. PLAY/ PAUSE
- starts or pauses CD play.
Back Panel (See 1 )
.
15 TELESCOPIC ANTENNA
- to improve FM reception.
16. BATTERY DOOR
- to open battery compartment
17. AC MAINS
- inlet for power cord
POWER SUPPLY
Power Supply
Whenever convenient, use the power supply if you
want to conserve battery life. Make sure you remove
the plug from the set and wall outlet before inserting
batteries.
Batteries ( not included)
open the battery compartment and insert eight
batteries, type R-14,UM-2 or C-cells, (preferably
alkaline) with the correct polarity as indicated by the
" + "and "-". symbols inside the compartment.
Batteries contain chemical substances, so they
should be disposed of properly.
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
. Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
. When inserting new batteries, do not try to mix old
batteries with the new ones.
. Remove the batteries if the set is not to be used
for a long time.
Using AC Power
1 . Check if the power voltage, as shown on the type
plate located on the bottom of the set, corresponds
to your local AC power supply. If it does not,
consult your dealer or service centre.
2 . Connect the power cord to the AC MAINS inlet
and the wall outlet. The power supply is now
connected and ready for use.
3 . To switch off completely, unplug the power cord
from the wall outlet.
Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
EN-4