System Troubleshooting - Diamond blue sea Manual De Usuario

SYSTEM TROUBLESHOOTING

PROBLEM
WATER LEAKS
LITTLE PRODUCTION
When opening the tap, the
supply immediately halts,
leaving a slight continuous
drip.
LITTLE PRODUCTION
The equipment is
continuously rejecting
water in the drainage.
THE EQUIPMENT
IS NOT PRODUCING
WATER
CHANGES FLAVOR
BAD WATER
APPEARANCE
POSITION
Container cups:
Connection fittings;
Thread part
Connection fittings;
Tube part:
Tap dispenser:
The accumulator is
completely full:
The accumulator is empty:
The accumulator
does not get full:
The accumulator
is quite full:
The accumulator is empty:
The accumulator is empty:
The water has a milky
appearance on the surface
after being served from the
tap:
The joint of the vessel is dirty, badly placed or
pinched.
Teflon ring is missing.
Fitting is incorrectly installed.
Threaded fitting.
Tube is badly cut or pinched.
Regulate the height of the dispenser.
To do so, please remove the nozzle and the
push button.
If the seal is worn out, replace the tap
Lack of air in the accumulator, replace
(between 0.3 kg and 0.5 kg).
The faucet is closed.
Accumulator membrane is damaged, water
flows out of the air inlet valve.
Replace the accumulator.
Please wait 3 to 5 hours to have the battery
full.
The inlet valve of the accumulator is closed.
Excessive air in the accumulator. Check the
pressure (between 0.3 and 0.5 Kg).
Dirty filters Change.
The inlet pressure is less than 3 kg / cm
Install a pump
Membrane is in poor conditions. Change.
Flushing valve is open.
SHUTOFF valve is dirty, has a broken
membrane or does not work. Change.
The non-return
membrane container does not work. Change.
Possible water leak.
Clogged filters
Inlet is clogged, broken or closed.
Membrane is stuck.
Change of mineralization in water due to
saturation or
membrane (change).
Air pockets accumulated in the general
accumulation network or in the osmosis
equipment.
19
SOLUTION
elbow placed
obstruction of filters
EN
.
2
in the
or