The flames should look like those in Figure 13. To clean the
burner, use a soft brush after the burner has cooled completely.
Never use a vacuum cleaner on the burner. It is recommended
to store the fire pit indoors during winter if it will be subjected to
freezing temperatures. The LP cylinder must be disconnected
and removed from the appliance before the appliance can be
stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
1. Read instructions before lighting.
2. Push and turn the knob to ON.
3. Hold ignitor to light the burner, release control knob after 15 seconds; if burner does not
light, wait 5 minutes, repeat.
4. Adjust flame to desired flame with the control knob. See Figure 14.
Place the burner cover on the table top as shown in Figure 15.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE
SURE THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.
MAINTENANCE
LIGHTING INSTRUCTIONS
BURNER COVER ASSEMBLY
Figure 13
Figure 14
Figure 15
12
CONTROL KNOB