Important Recommendations; Work Area - TRAPP Master 1000 Manual De Instrucciones

Congratulations!
You have just acquired a quality product developed with the highest TRAPP
technology. This product shall provide agility and efficiency in works, with economy
and total safety. For such, some caution are necessary. The safety measure, extremely
serious, contained in this Instruction Manual, do not cover all possible situations
that may occur. The operator must that common sense, attention and caution are
factors that can be incorporated to the product, but that must be supplied by those
who operate and perform duly maintenance.
Note:
The following information may vary from one
country to another.
Important!
Read carefully before the use, and keep for future
consultation.
Attention!
Read all the instructions in this manual before
operating the equipment. Always observe and
follow the safety indications to prevent accidents
and/or injuries.
Attention!
In the brush cutter model Master 3000 one

must not use nylon spool.
20

Important Recommendations

Read and keep these instructions.

1 - Work area

Inspect the area where the equipment shall be

used. Remove all stones, pieces of wood, wires,
bones, glasses and other foreign objects that can
be released by the equipment and cause severe
injuries to people or animals.
Do not operate the equipment close to

explosive atmosphere, or where there are
flammable liquids, gases or airborne dust.
The equipment electric engine produces sparks
that may cause ignition to flammable liquids,
gases or airborne dust.
This apparatus is not intended to be used by

persons (including children) with reduced
physical, sensorial or mental capacity or by those
lacking experience and knowledge.
It is recommended that children are supervised

in order to assure they are not playing with the
apparatus.
Before turning on the machine to the power

source - Make sure the voltage of the power
source (127 V or 220 V) is the same of the
equipment.
The brush cutter model Master 3000 has a voltage

selector that can be adjusted in accordance with
the power source voltage before turning on the
equipment.
www.trapp.com.br