Code Search; Brand Search - Zenith ZH210 Manual Del Propietário

Code Search

If your product does not respond after you have tried all the codes
for your brand, or if your brand is not listed, try searching for your
code by following these steps.
1. Manually turn on the device (TV, VCR, etc.) to be controlled.
2. Press and hold the CODE SEARCH button until the red indica-
tor stays on, then release the CODE SEARCH button.
3. Press and quickly release the desired mode button (TV, VCR,
etc.). The red indicator blinks off once.
4. Press the CHANNEL UP button repeatedly (up to 300 times)
until the device to be controlled changes channel. The red indicator
blinks off with each button press. If you accidentally overshoot the
code required, press the CHANNEL DOWN button to backtrack
through the library until the device changes channel. Pressing
CHANNEL UP changes direction to forward again.
5. Press and release MUTE to install the code.
Most users will store VCR codes under the VCR button, Cable
codes under CABLE, etc. If (for example) you want to store a
VCR code under CABLE, first follow the procedure for Direct
Code Entry and press CABLE in step 2 of Direct Code Entry, then
enter ANY VCR code in step 3 of Direct Code Entry. Then follow
the steps above for Code Search (or Brand Search, below). Note:
If the device does not have a CHANNEL UP button, use PLAY
(VCR only) or POWER instead. Code Search starts from the cur-
rently stored 4 digit number under that mode.
Code Search by Brand
Lets you search for a code for a specific Brand within the Code
Library for a particular manufacturer.
1. Turn on the device (TV, VCR, etc.) to be controlled.
2. Press and hold the CODE SEARCH button until the red indica-
tor remains on, then release CODE SEARCH button.
3. Press and quickly release the desired mode button (TV, VCR,
etc.). The red indicator blinks off once.
4. Press and release the numeric button (0-9) corresponding to
desired Manufacturer (see table below). The red indicator blinks
off once. Note, pressing "0" performs a full library search same as
normal Code Search Method on previous page.
5. Press the CHANNEL UP button ((or POWER or PLAY (VCR
only)) repeatedly until the device to be controlled changes chan-
nel. The red indicator blinks off with each button press. If you
accidentally overshoot the code required, press the CHANNEL
DOWN button to backtrack through the library until the device
changes channel. Pressing CHANNEL UP changes direction to
forward again.
6. Press and release MUTE to install the code. Brand Search Meth-
od entry is now complete. Note: When all codes under a Brand
have been searched the red indicator flashes rapidly for 3 seconds.
1 RCA, GE, SA
2 Zenith
3 Philips, Magnavox
4 Sony, Panasonic, Toshiba, Sharp, Pioneer
5 LG, Samsung, Hitachi, JVC, Sanyo
6 Echostar, Sylvania, Dish, Emerson, Fisher, Hughes
0 All
6