Installation - universalblue UBT2500-20 Manual De Instrucciones

INTERNAL WIRE DIAGRAM

3. INSTALLATION

INSTALLATION INSTRUCTION
1. This electrical water heater shall be installed on a solid wall. If
the strength of the wall cannot bear the load equal to two times
of the total weight of the heater filled fully with water, it is then
necessary to install a special support. Incase of hollow bricks
wall, ensure to fill it with cement concrete completely.
2. After selecting a proper location, determine the positions of the
two install holes used for expansion bolts with hook (determined
according to the specification of the product you select). Make
two holes in the wall with the corresponding depth by using a
chopping bit with the size matching the expansion bolts
attached with the machine, insert the screws, make the hook
upwards, tighten the nuts to fix firmly, and then hang the electric
water heater on it (see Fig.2).
28