Publicidad
Idiomas disponibles
Idiomas disponibles
De-activating of functions currently active
> First press the button CH-
The lamp confirms with 3 flashes
> Press the corresponding number on the remote hand set,
according to the above list of assignment.
The lamp confirms with 3 short flashes and returns to the programme last being
active without any further function
Troubleshooting
Press the RESET
button
The lamp returns to the pre-fabricated settings
and you may now programme it again.
4. Compatibility
If the quantity of lamps is set to 16 (factory-made setting), the TopLED Synchro can be used
within installations of other manufacturers as long as they work with the same or similar
principals (DCF synchronization evaluations).
5. Technical Data
Operational area from the radio transmitter (D-Frankfurt) approx. 2.000 Km*)
Self-synchronising
Flash rate approx. 60/min
Light intensity, imp.: 110 cd
Operating time: approx. 116 days / 50 Ah, night
approx. 58 days / 50 Ah, day-night
approx. 60 days / 28 Ah, night
approx. 30 days / 28 Ah, day-night
10
*) Receipt of radio signal may
vary temporarily depending on
thunder and lightning close to
the lamp's working place.
6. Loss of the remote hand set or assembly of a set with single lamps
without a remote hand set.
The TopLED Synchro contains an inter-
nal DIL-Switch (A) and a circuit connec-
tor „JUMPER" (B) in order to change the
number of lamps and the kind of operation:
NIGHT operation or DAY-NIGHT operation.
Disengage the 4 screws of the lens and re-
move the lens.
On top of the circuit board, there is a DIL-
Switch (A) with four single switches. In a set
of five lamps, the four single switches are set
on the position OFF.
Placing a new number of lamp i.e. number 3
> Switch OFF the lamp with the pin key.
> View the attached table and look for the
switch setting for number 3 and convert
the DIL-Switch
> Switch ON the lamp.
The lamp confirms
On top of the circuit board, there is a so-cal-
led „JUMPER"(B), sitting on a four-pin connector. In a set of five lamps, the JUMPER is
placed on the two upper pins.
Two upper pins = night operation
Two lower pins = day-night operation = B2
DIL-
Switch
1
2
3
4
5
6
1
2
ON ON ON ON
3
ON ON
ON ON
4
ON
ON
ON
Changing from only night to day-night operation
> Switch OFF the lamp with the pin key.
> Place JUMPER (B1) on the two lower pins (B2)
> Switch ON the lamp.
The lamp confirms
By a factory-made supplied single lamp, please proceed like before.
The DIL-Switch in single lamps is always set on „Lamp 1".
Programming single lamps by DIL-Switches limits the maximum number of lamps is a set
to 15 lamps !
-
Subject to alterations !
= B1
number of lamp
7
8
9
10
11
12
13
14
ON ON ON ON ON ON ON ON
ON ON ON ON
ON ON
ON ON
ON
ON
ON
ON
15
16
ON
11
Publicidad
