2- Installation With Latch Anchors And The 3-Point Seat Belt - JANE Montecarlo R1 Instrucciones

Installing your Montecarlo R1 in the Vehicle
2 Installation with LATCH anchors and the 3-point seat belt
2a
14
All manuals and user guides at all-guides.com
LATCH
2b
If you are going to install your MONTECARLO R1 with the rigid anchors,
follow the steps below carefully:
2a First remove the end caps, to do this, pull the anchor button. Keep
the end caps in case you use the MONTECARLO R1 without LATCH in
the future.
2b Pull the anchor out pressing the red buttons on the sides (13).
2c Make sure that both anchors are open, the red signal should be
displayed on the anchor button (12).
2c