Heylo KT 20 Serie Manual De Instrucciones página 22

2. Ensure that the drain hose is re-
moved from the device and that
the mains plug is disconnected.
3. Transport the device to the loca-
tion of operation.
4. To transport heavy loads, work in
teams of two and use suitable lift-
ing gear.
5. When the device is at its location
of operation, apply the transport
wheel brake.
NOTICE! Ensure that the air can
circulate freely around and through
the device. Do not cover the air
inlet and outlet openings. The dis-
tance between the air outlet and
the air filter must be minimum 1 m.
Unpacking
1. Remove the device from the card-
board box and place it on the
ground.
2. Check the delivery for complete-
ness.
Report any transport damage or
incomplete delivery to your dealer.
Adjusting handle
1. Loosen the two knurled screws,
pull the handle to the desired posi-
tion and then tighten the knurled
screws.
Connecting drain hose
For operation, the supplied drain hose
must always be connected to the
device.
22
ATTENTION! Poor device perfor-
mance
 Do not kink the drain hose.
 Do not place any objects on the
hose.
Procedure
1. Secure the quick-release coupling
of the drain hose to the connector
at the rear of the device.
2. Lead the drain hose away from the
device and place the free end in
an on-site drain opening or a suffi-
ciently large collecting vessel
(maximum level difference: 6 m).
Connecting hygrostat
1. Connect the hygrostat (HEYLO
prod. no. 1110552) to the port at
the rear of the device.
 The device automatically recog-
nises the hygrostat and then runs
in continuous mode until the tar-
get humidity is reached.
Stacking devices
For operation or storage, it is permis-
sible to combine maximum two devic-
es in a stack.
1. Do to this, loosen and fully retract
the handle of the device at the bot-
tom.
2. Place the second device on the
first one. Ensure that the bases of
the second device slot into the re-
cesses in the first one.
Connecting device to electric
power mains
1. Ensure that the voltage of the
power mains corresponds to that
specified in the Technische
Daten/Technical Data.