Scope Of Delivery - Kaco Bending-box on blueplanet 87.0-165TL3 Guía Rápida

1 Retrofitting the bending box
NOTE
This component is a mandatory requirement for the UL market. Therefore, it must also be installed before a
KACO blueplanet 87.0-165TL3 XL inverter is put into operation.

Scope of delivery

ž 1x "bending box" component
ž 1x left-hand pedestal
ž 1x installation manual (multi-language)
Mounting kit required
ž
Included in the scope of supply of the 87.0-165 TL3 in-
verter
Technical data
Allgemeine Daten
Protection class / overvoltage category
Max. cable cross-section
Min. cable cross-section
Fitting for DC connection
Diameter of cable for cable fitting
Torque for cable fitting
Interface screw connections
Diameter of cable for cable fitting
Torque for cable fitting
Housing material
H x W x D
Weight
Remove the pedestal and DC input plate on the inverter
↻ The inverter is securely installed.
1 Unfasten the left-hand pedestal from the housing base of the inverter and place
in inverter packaging. [
2 Unfasten the input plate from the housing base of the inverter and make avail-
able for component. [
3 Set the screws for fastening the components to one side.
» The inverter is ready for component assembly.
Installing the component
↻ Left-hand pedestal and input plate removed.
1 Unfasten the housing cover of the inverter using the 6 screws and remove care-
fully [ T_25]
2 Lift the component by the DC input opening of the inverter and mount it provi-
sionally from below using the 4 screws that have been set to one side.
3 Tighten the fastening screws in a diagonally opposite sequence. [
44.25 In-Ibs ]
» The component is securely installed. Proceed with the DC connection.
Bending-box S; XL Version
T_30].
T_30].
1x
Fig. 1: Mounting kit required
IP66 / NEMA 4X
450 kcmil
acc. to local installation standards
M40
0,63 - 1,10 inch
88.5 In-Ibs
2x M15 max 15 AWG
9 AWG
44.25 In-Ibs
Aluminium
13,62 x 9,05 x 6,96 inch
3,52 Ibs
Fig. 2: Removing the pedestal and
DC input plate
1
2, 4 Fastening screws
3
T_30 /
Fig. 3: Mounting the component
on the inverter
1
2
3
2x
4x
2x
2x
2x
4 3
1
2
Input plate
Pedestal
1
2
3
Housing cover on inverter
Component
Fastening screws
Page 54