Getting Started - Labelmate PM-300-CS Manual De Instrucciones

Getting started

SET-UP
• Connect the unit to a 230V mains using the supplied power cord. The ON/OFF switch is located near the power inlet.
The machine is protected by a fast-blow fuse of 3.15A and a spare fuse is provided in the fuse older.
• The machine is fitted with 2 photo-switches positioned left and right from the speed control roller. The left-side pho-
to-switch is used for the "out of paper" function. The right-side photo-switch detects the label and is used by the internal
counter; the signal is also available on the interface connector.
FRONT CONTROL PANEL
• POWER (GREEN): Indicates power is applied to the unit. The ON-OFF Power Switch is on the rear of the Unit.
• ERROR/STOP (RED): Indicates that either the unit is in STOP mode or one of these three Error Conditions has occurred:
1. The unit is out of paper
2. The count has reached the Pre-Set Value
3. There is a Print-Head Error condition. E.g. No more ink. (condition valid only if the Print Head supplies this signal)
• FOR CS MODEL ONLY INK LOW (RED): Indicates that the Print Head has sent an Ink-Low Signal
• FOR CS-STEP MODEL ONLY 1 BY 1 (RED): Indicates that the "1 by 1" mode has been selected by the switch on the
rear panel.
• GAP (YELLOW): Flashes when Unit is running, indicating proper detection of the gap between successive labels.
• START BUTTON (WHITE): Start printing, if no Error Condition is present.
• STOP BUTTON (RED): Holding down this button will stop the machine when the next gap passes in front of the photo-
cell.
• SPEED CONTROL: Varies the speed from zero to maximum.
POWER
ERROR/STOP
INK LOW
GAP
SPEED
PM-300-CS
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
START
STOP
PM-300-CS-STEP
START
POWER
ERROR/STOP
1 BY 1
STOP
GAP
SPEED