universalblue T 90 Manual De Instrucciones página 33

To replace the bulb, please consider the following instructions:
 Remove the grease filter.

Find the junction box, unscrew the screws from the cover of
the junction box, then remove the cover from the junction box
(if there is a wire pressure plate that pressed the light wire,
the wire pressure plate must be removed first). See photo 1.
The connection box can vary from one model to another (Box
A or B of the drawing below)
 Find the terminal of the light connection cable and remove it.
See photo 2.
o Option 1: Use a tool or hand to press the spring
o Option 2. Use a straight screwdriver to lift the lower
 Apply the reverse procedure to reinstall the light
splinter from both sides of the LED light inward, until
the light goes out, (image 3). Then, slightly pull out the
light connection cable, (image 4).
edge of the LED light (photo 5), then slightly pull out
the light connection cable, (photo 4).
33