Quick DP3 Serie Manual Del Usuario página 15

WARNING
WARNING: stay clear of the chains, ropes and gypsy. Make sure the electric motor is off when windlass is used manual-
ly (even when using the handle to disengage the clutch). In fact people with windlass remote controls (hand-held remote
control or radio-controlled systems) might accidentally operate it.
WARNING: secure the chain with a device before starting the navigation.
WARNING: do not operate the windlass by using the electrical power when the handle is inserted in the drum or into
the gypsy cover.
WARNING: Quick ®
ing or shortcircuits. For AC currents the use of a fuse is recommended (details on its dimension are specified in the page
of the connection diagram); For DC currents the use of a specific and delayed-action (thermal-magnetic or hydraulic-
magnetic) circuit breaker is recommended. The circuit breaker can be used to cut off power to the windlass control
circuit and so avoid accidental activation.
CLUTCH USE
The clutch (6 and 8) provides a link between the gypsy (7) and the main shaft (16 or 18). The clutch can be released (disengage-
ment) by using the handle (1) which, when inserted in the bush (3) of the drum or into the gypsy cover (5), must be turned
counter-clockwise. The clutch will be re-engaged by turning it clockwise (engagement).
WEIGHING THE ANCHOR
Turn on the engine. Make sure the clutch is engaged and remove the handle (1).
Press the UP button on the control provided.
If the windlass stops and the hydraulic magnetic switch (or thermal cutout) has not tripped, wait a few seconds and try again
(avoid keeping the button pressed).
If the hydraulic magnetic switch, has tripped, reset it and wait a few minutes before weighing anchor once again.
If, after a number of attempts, the windlass is still blocked, we suggest to move the boat to release the anchor. Check the up-
ward movement of the chain for the last few meters in order to avoid damages to the bow.
CASTING THE ANCHOR
The anchor can be cast by using the electrical control or manually. To operate manually, the clutch (6 and 8) must be disen-
gaged allowing the gypsy (7) to revolve and letting the rope or chain fall into the water.
To slow down the chain, the handle (1) must be turned clockwise.
To cast the anchor by using the electrical power, press the DOWN button on the control provided. In this manner, anchor cast-
ing is under control and the chain and rope unwind evenly.
In order to avoid any stress on the windlass -once the boat is anchored- fasten the chain or secure it in place with a rope.
DP3 700/1000/1500W - REV002C
recommends using a protection to prevent the engine line from suffering damages due to overheat-
USAGE
GB
15