Instructions For Use - Create MINI SLOW JUICER Manual De Instrucciones

4. Mount the filter in the press cup. Align the point of the filter with the point of the press cup (the largest
buckle with the largest slot). Insert the filter into the pressing cup.
5. Mount the feeding cup on the machine and rotate it to the correct position. Align the feed cup with the
press cup. Turn it clockwise until the buckle presses on the microswitch. After hearing a click, it indicates
that the installation is complete.
Make sure you clean your slow extraction blender well before using it.
1. Place the installed machine firmly on a level table.
2. Prepare the ingredients. Cut them into suitable pieces according to the different ingredients.
3. Turn the switch to the "STA" position and the device will start to work, and then put the ingredients into
the feeding cup. When the ingredients are too large to press gently, use the pusher plunger to push the
ingredients in properly.
4. If the ingredients are blocked in the press cup, turn the switch to the "REV" position for 3-5 seconds,
then turn the switch to the stop position, stop working for 1-2 seconds, and then turn the switch to
"STA" for normal work.
5. After use, remove the components from the juice and clean them in time. Please note that you need to
reinstall it on the filter after cleaning the filter silicone ring so that no parts are missing in the next use.

INSTRUCTIONS FOR USE

ENGLI S H
9