Descargar Imprimir esta página

Broan-NuTone HAWSK3 Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

HAWSK3 ADA KIT WIRING INSTRUCTIONS FOR ECONOMY RANGE HOODS
For residential (domestic) installation only. Before proceeding, switch power off at service panel and lock service
disconnecting means to prevent power from being switched on accidentally. Installation work and electrical wiring
must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated
construction codes and standards. Also, it is recommended to wear safety glasses and gloves.
THIS PROCEDURE APPLIES TO THE FOLLOWING RANGE HOOD SERIES
Broan Series: BUEZ0, BUEZ1, BUEZ2, BUEZ3, BU2, BXT1, 40000, F40000, 41000, 42000, 43000.
NuTone Series: NU2, RL62000.
A
CCESS TO RANGE HOOD CONTROL PANEL CONNECTIONS
Remove the wiring cover and set it aside with its screw.
If present, remove the plate covering the access to the unit
switches and set it aside with its screws.
Range hood series:
BUEZ0, BUEZ1, BUEZ2, BU2, BXT1,
40000, F40000, 41000, 42000, NU2 and RL62000.
Label, then disconnect the BLUE and the RED wires from motor
switch terminals, and the single BLACK wire from the light
switch terminal. Disconnect from the motor switch terminal and
from the light switch terminal the BLACK wire and discard it. Cut
off and discard the connectors from the BLUE, the RED and the
BLACK wires.
MOTOR SWITCH
TERMINALS
BLUE
WIRE
DISCARD THIS
BLACK WIRE
MOTOR SWITCH
TERMINALS
RED WIRE
BLUE
WIRE
To suit your needs, there are 2 ways to wire the ADA HAWSK3 to this range hood: 120 VAC power cable entering the switch box (page 2)
and 120 VAC power cable entering the range hood (page 3).
CAUTION
Only use switches included in HAWSK3 ADA kit. Only
use wires suitable for at least 90oC (194oF).
NOTE:
Do not use the green screw and the ADA wire harness
included in HAWSK3 ADA kit.
NOTE:
If the HCK44 Power cord kit is used to connect the unit, install the provided ground screw (A)
on the unit grounding plate.
LIGHT SWITCH
TERMINALS
BLACK WIRE
RED WIRE
LIGHT SWITCH
TERMINALS
BLACK WIRE
WARNING
!
Range hood series:
Label, then disconnect the RED and the BLACK wires from
motor switch terminals, and the single BLACK (or BLUE) wire
from the light switch terminal. Disconnect from the motor switch
terminal and from the light switch terminal the BLACK wire and
discard it. Cut off and discard the connectors from the RED, the
BLACK and BLACK (or BLUE) wires.
MOTOR SWITCH
TERMINALS
RED
WIRE
MOTOR SWITCH
TERMINALS
RED WIRE
HIGH
Motor speed
selection
switch
(3-way)
LOW
1
BUEZ3 and 43000.
LIGHT SWITCH
TERMINALS
BLACK OR
BLUE WIRE
BLACK WIRE
DISCARD THIS
BLACK WIRE
LIGHT SWITCH
TERMINALS
BLACK OR
BLUE WIRE
BLACK WIRE
OFF - ON
ON/OFF
Motor switch
ON/OFF
Light switch
A
99043739F

Publicidad

loading