Accessories; Examples Of Installation; Troubleshooting - Montarbo R Serie Manual De Uso

R SERIES

ACCESSORIES

8
Pair of tripods CV-R108/R110/R112/R115/R15S/R18S

EXAMPLES OF INSTALLATION

9
INSTALLATION OF A SPEAKER ON A TRIPOD STAND
The speaker can be installed on an optional standard tripod stand with 35 mm diameter
pole. The maximum permissible height between the speaker base and the floor is 170 cm
for R108, R110, R112 and 150 cm for R115. Any other use requires additional fixing (not
supplied).
INSTALLATION OF A WEDGE SPEAKER
The speaker can be positioned, using the angle of the cabinet, as a live monitor. In this
case, we recommend selecting the WEDGE preset on the control panel.
INSTALLATION OF A SPEAKER ON A SUBWOOFER WITH POLE
By using the prearrangement on the top of the subwoofer, it is possible to screw on a standard
24
Kit of 4 wheels
cover for subwoofers
M8
R108-R110
M10
R112-R115
pole for mounting a speaker on a subwoofer. In this case the maximum permissible height
between the base of the speaker and the floor also depends on the supporting subwoofer.
With R18S: 180 cm (R108-R110) or 150 cm (R112-R115). With R15S: 170 cm (R108), 150
cm (R110-R112), 120 cm (R115). These heights refer to the alignment of the sub front and
speaker front. Any other configuration requires additional fixing (not supplied). In the case
of a subwoofer - speaker link, select the possible crossover.
INSTALLATION WITH EYEBOLTS
The speaker can also be installed using eyebolts. The positioning is shown in the figure on
the side, where the rear eyebolt allows adjusting the final angle (MAX 45°).
Positioning is intuitive. For amplifying to a seated or standing audience, the use of certified
stands is recommended, placed on a flat surface and with power and signal cables placed
so that they cannot be walked on, are not stretched and cannot present a risk of tripping
or poor safety.

TROUBLESHOOTING

10
The speaker/subwoofer does not power up
Check that there is a correct power supply upstream from the system.
Check that the power cable with VDE connector is plugged in properly.
The speaker/subwoofer powers up but does not emit any sound
Check that the connections to the audio channel inputs (CH1, CH2) are correct.
Check that the cables used are not interrupted. Use only quality cables in good condition.
Check that the audio sources are switched on and show an output signal.
Check that the input sensitivity of CH1 (for speakers) is correct.
Check the volume of the MAIN (speaker) or LEVEL (subwoofer) output.
The speaker/subwoofer emits low or distorted sound:
Adjust the appropriate source volume for the mixer section inputs.
Check that the cables used are not damaged. Use only quality cables in good condition.
Check the volume level of the inputs and the MAIN (or LEVEL for the subwoofer).
Lower the level of the MIC, LINE and/or MAIN inputs.
Make sure you have not connected a line signal to channel 1 with MIC sensitivity.
Check the crossover filter cuts, in case of a subwoofer-speaker link
Presence of background noise
Turn off the power and disconnect all connected devices.
Check the signal from all sources to find out which one caused the problem.
user manual
25