HQ-Power VDPC146 Manual Del Usuario página 7

Ocultar thumbs Ver también para VDPC146:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
7) Recording a Chase
• Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator lights up.
• Select the desired page with the PAGE button.
• Slide both master faders (MASTER A = 10 and MASTER B = 0) to the highest position
• Place the 24 channel sliders in the desired position.
• Press RECORD to store the scene in the memory
• Place the 24 channel sliders in the desired position again.
• Press RECORD to store this second scene in the memory
• Repeat the last two steps until a max. of 999 scenes have been programmed
• When you're done programming, slide both master faders (MASTER A = 0 and MASTER B = 10) to the bottom
• Press the desired flash button (13 – 24)
• Release the RECORD button
The chase is now stored under one of the keys of n°7 in fig. 1 on page 2.
8) Deleting a Step from a Programme
• Hold the EDIT button
• Press the desired flash button (13 – 24).
• Release the EDIT button. The yellow LED indicator of the selected scene is lit.
• Bring the speed fader down (to SHOW MODE) and use the STEP button to find the scene to be deleted
• Press the DELETE button to remove the step.
9) Inserting or Adding a Step to a Programme
• Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator lights.
• Use the PAGE button to select the page (1 – 4) where the scene is to be added or inserted.
• Slide both master faders (MASTER A = 0 and MASTER B = 10) to the lowest position, place the FADE slider in
the highest position and the SPEED slider in the lowest position (SHOW MODE).
• The channel fader of the step to be inserted should be slid upwards.
• Press RECORD
• Select CHASE/SCENES (red LED indicator is lit) with the MODE SELECT button
• Hold the EDIT button
• Press the flash button of the scene that has to be inserted in that step.
• Release the EDIT button (the yellow LED indicator of the selected scene is lit)
• Press the STEP button until you reach the scene that will immediately follow the scene to be inserted
• Press INSERT to add the scene to that programme step.
• Hold the RECORD button
• Press the REC EXIT button
• Release both buttons to leave the programming mode
10) Selecting and Running a Programme
• Press MODE SELECT until the green LED indicator marked '1-24 SINGLE / PRESET PARK' is lit.
• Select the desired page (1 – 4) with the PAGE button
• Slide the MASTER faders to the highest position
• Move the channel slider for the scene in question to the lowest and then the highest position to select and run the
programme stored under that fader.
VDPC146
7
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido