Cleaning & Maintenance; Auto Clean - Igloo IGLICEND40SS Manual De Instrucciones

ICE MAKER NOT WORKING
If the ice-making cycle seems to be running properly, but no ice is being made, try the following:
• The water temperature in water tank may be too high. Try pouring
colder water (between 45˚ F - 80˚ F) into the water tank.
• Make sure you are using the ice maker in a room with an ambient
temperature between 68˚F to 74˚F or lower
• If changing the water or allowing the unit to cool does not work, there may
be a leakage of the refrigerant fluid, or a pipe in the cooling system may be
blocked. Please take your ice maker to a qualified technician for repair.
CLEANING & MAINTENANCE
Your DISPENSING NUGGET ICE MAKER should be cleaned before first time use and before
storing. Following these steps will help to maintain the unit and add to longevity.
1. Unplug the unit from the electrical outlet.
2. Dispense all ice from the machine.
3. Remove water tank drip tray.
4. Drain water by turning the drain cap on the button of the unit.
5. Clean the interior and exterior with lukewarm water and a soft cloth.
6. Clean the water inlet with a straw brush
7. Dry the interior and exterior with a soft, non-abrasive cloth.
8. Close the drain cap.
9. If the unit has not been in use for a long time, always open the Water Drain
Plug and completely drain the water from the Water Reservoir.

AUTO CLEAN

1. Add a solution of about half water and half white vinegar or
lemon juice to the water tank up to the max fill line.
2. Plug the ice maker into the wall outlet.
3. Make sure the ice maker is in standby mode, then press then hold button the "ON/OFF"
Button for 3 seconds. The ring around the power button will turn purple, indicating
that the ice maker is in auto cleaning mode. This will take approximately 8 minutes.
4. Unplug the drain in the back of the ice maker to drain all liquids.
5. Fill the water tank with water up to max fill line.
6. Repeat steps 1-4.
8