Operating Modes - Elnur Gabarron TCROM Serie Instrucciones De Instalacion Y Uso

OPERATING MODES

Press the [On/Standby] button to turn on the device or to enter the "Standby/Antifreeze" mode.
NOTE: When the device is switched to "Standby/Antifreeze" mode, it beeps twice for 0.5sec. When the device is
switched to "On" mode (i.e. it is turned on), it beeps for 1sec.
"Comfort" mode: In this mode the desired temperature of the radiator is selected. The temperature value is set
through the [+] and [-] buttons to one of the following values:
40°C, 45°C, 50°C, 55°C, 60°C, 65°C.
The rightmost lit or blinking LED in the "Comfort bar" indicates the selected temperature. A blinking LED indicates
that the corresponding temperature has not yet been reached during the heating phase. When a certain temperature
level is reached, the corresponding LED stops blinking and remains lit.
Example:
Additional indications provided by the "Comfort Bar":
- The two central (yellow) LEDs blink when a button is pressed: Key lock is active.
- The external (blue and red) external LEDs blink: Failure on the temperature sensor, the heating element is
deactivated. Contact customer Support (+34 916281440).
"Standby/Antifreeze" mode: In this mode the device goes in standby, however as soon as the temperature of
the radiator falls below 10°C, the heating element is automatically powered on.
The device is firstly turned on. Pressing 4 times
the [+] button, the desired temperature is set to
a value of 55°C (the first 4 LEDs from the left
start blinking).
The radiator
temperature of the radiator reaches 40°C the
first (blue) LED stops blinking and remains lit.
After some time, the temperature reaches 45°C
and the second (green) LED also stops blinking
and remains lit.
The same behavior applies to the two
subsequent (yellow) LEDs, until the desired
temperature of 55°C is reached (all LEDs stop
blinking).
8
starts heating. When the