Blade Tightening / Lubrication / Replacing The Blades - Active TIGERCUT 40 Manual Del Usuario

Blade tightening
For all these operations you must disconnect the pruning shears
Notice!
It is possible to have a slight movement in the direction of blade
closure. This movement is normal and may be caused by the gap
between the rack and pinion teeth.
Lubrication
For all these operations you must disconnect the pruning shears
Lubricate blades twice a day using Active speci c lubricant.
Replacing the blades
Please cut o the power source of the shears before operation.
When the entire length of the moving blade no longer coincides well with the xed
blade, or if the blade after grinding is still not clean after cleaning, it is recommended to
replace the blade. The replacement steps are as follows:
1. For safety, please power o before replacement and remove the battery.
Follow the steps below to replace the blade.
2.
3.
After the replacement, clean it, connect the battery, check the power and close
the blade.
1
Unscrew clockwise
2
22
3
4