Leuze electronic ELC 100 Serie Instrucciones De Usuario página 9

Device/Operating mode
Transmitter
Receiver
For further information on the pin assignment, see the ELC 100 operating instruc-
tions.
Testing
1 Green
2 Green/yellow+red/red
Ä
Check status LEDs: continuously lit
If not as specified: troubleshoot as instructed in the ELC 100 operating instruc-
tions, chapter 10 "Diagnostics and troubleshooting".
Alignment
Ä
Loosen screws on the mounting brackets.
Align transmitter or receiver by tipping, tilting and turning.
Ä
Before starting the alignment process, briefly disconnect the receiver from the
power supply.
Ä
Turn the receiver from left to right until all 4 pairs of the blue alignment LEDs
illuminate permanently. As soon as this optimum point is exceeded, the blue
LEDs switch off or flash one after the other.
Ä
Tighten the fastening screws of the receiver.
Ä
Briefly disconnect the receiver from the power supply.
Ä
Now align the transmitter according to the same method, paying attention to
the display elements of the receiver while doing so ("Display elements").
Optimum alignment:
Middle of the angle of rotation at which all 4 LEDs light up continuously.
Ä
Retighten alignment screws.
M12 connector
5-pin connector
5-pin connector
Connection
Connection to the ma-
chine interface
EN
9