camry Premium CR 4011 Manual De Uso página 8

will stop.
Please note than if the seed or nut is too big or gets stuck the device will stop. Please then turn the device off
and mix the seeds or nuts in the hopper with an wooden spatula. NEVER PUT YOUR HAND INTO THE
HOPPER IF THE DEVICE IS POWERED.
If the device does not start please press the REVERSE (15) button for a few seconds. Then press the Start /
Pause button again and check if the device is working again.
WARNING: The appliance motor will stop after a short while after pressing the Stop button. It is to ensure the
device from clogging. Please wait for the motor to stop. Then open the lid of seed container.
NOTE: The device is not designed for pressing SOYA BEANS OR OLIVES.
TIP: Start processing with a small amount to test the quality and the moisture content.
Special notes:
1. Peanut oil: To ensure the device is not getting stuffed and the engine does not stop. Please fry the peanuts
dry before pressing. The size, hardness and quality are different in each batch.
2. Please make sure to use the highest quality nuts and seeds.
3. Please make sure to choose 90% dryness material. We suggest to fry the materials with low temperature for
half an hour or put out into the sun for one hour.
4. Please press only as much oil as you need per day. The health benefits of fresh pressed oils are the best
and if not stored correctly will dissipate fast.
Guide to the control panel lights:
Status of the light = Machine status
Quick flashing red light = Pre Heating
Constant red light = Powered on but the start not pressed
Slow flashing red light = Paused
Green light = Working
Quick flashing green light = Reverse gear
Flashing green and red light with noise = Machine not working correctly. Please check if assembly is correct
and nothing is blocking the oil press. If the machine is assembled and not blocked please contact the seller or
warranty service for support.
Technical details:
Voltage: 220-240 V ~ 50/60 Hz
Power: 650 W
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
8