Mx Onda MX-HD2410 Manual De Instrucciones página 23

Using the dental wáter jet
1. Check that the battery is charged.
2. The dental water jet must be turned off, a full tank of
water or solution and the nozzle inserted.
3. Stand over the sink and tilt your head at an angle of
about 45 degrees, then enter the nozzle outlet in the
mouth.
4. Press the on/off button 5 (
start operating in the last level of the selected flow
pressure water.
5. During cleaning, you can increase or decrease the
pressure of water flow through the 6 button, each time
you press this button will decrease the pressure. If the
selected pressure is the minimum, pressing the button
6 again select the maximum pressure.
6. To remove the dental water jet to rinse the mouth, rest
or finish cleaning, switch off the irrigator using the
on/off button 5 (
mouth shut if before it.
Very important:
Do not use this device continuously for more than 5
minutes. Remember that the irrigator has a timer
that switches off after 2 minutes.
To prevent overheating of the pump, never operate
the irrigator without water or solution for a long time.
CLEANING
After each use, empty the water tank.
Clean the surface irrigator with a damp cloth and dry
with another dry. Do not use alcohol or abrasive
products.
Do not insert the device in water or any other liquid.
) and dental water jet will
). Never remove the irrigator of
7