Volpi KVS8000P Manual Del Usuario página 38

Oil quantity
3
display
Electronic board
4 temperature
display
8.3. Error codes and descriptions
Displayed
Error description
code
E1 Chain rotation locking
E2 Hardware over-voltage
E3 Circuit failure
E4 Incorrect voltage
E5 Undervoltage
E6 Overvoltage
E7 Overvoltage softwere
E8 Phase loss
E9 Low battery capacity
E13 Oil pump failure
E15 Overtemperature MOS
Note: if the problem is not clear, always contact with a service center.
38
Oil quantity
settings
Degrees
°C
centigrade
Overextended chain or
motor/ reducer locking
The red-light
flashes
1. Quantity oil settings:
press the button
flashes and press the button
the required quantity of oil. Press the
button twice to finish the adjustment.
2. Forced lubrication:
press the button
the forced lubrication and the icon
starts flashing. Press the button
seconds to stop the lubrication.
Non modifiable
Cause
Excessive force during
work or driver failure
Driver failure
Driver failure
Low Battery
Battery failure
Activated protection
Motor failure or cable
failure
Battery failure
Oil pump failure
Driver protection
until the symbol
to select
for 3 seconds to start
for 3
Solution
Check chain tension or
contact service center
Adjust the force or
contact service center
Contact a service
center
Contact a service
center
Charge the battery
Substitute the battery
Automatic reset
Contact a service
center
Substitute the battery
Contact a service
center
Automatic reset