Charging The Device - UFESA CP6850 UNDERCUT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
To lock the comb at your desired length, slide the lock switch
down.
It is advisable to begin with the highest setting and then reduce
the setting until you reach the desired hair length.
Push upward the on/off switch (4). Hold the comb with the an-
gled edge against your head and guide the trimmer against the
direction of the hair growth.
Please always push down the on/off switch (4), and switch off the
hair clipper when you finish clipping the hair.
To avoid clogging the comb with hair, clean it from time to time
with the cleaning brush (8)
To thin hair out, move the thinning function button (2), this ac-
cesses the hair thinner comb (1) integrated in the cutting head
(6). This function enables you to reduce hair volume, obtaining
a modern, shaggy look without altering the length of the hair.

CHARGING THE DEVICE

The hair clipper is completely handy to carry and can be charged
anywhere with the USB cable (10). Comes with built-in battery, a
full charging time is about 1.5 hours and offers around 90 minu-
tes of running time.
First insert the plug on the end of the USB charging cable lead
into the unit and then connect the USB charging cable to the USB
interface. This appliance is suitable for 5V DC Max 1A charger,
computer and other power interface.
The LCD Display (5) will show the remaining power percentage.
When the battery is too low, the LCD will flash "LO" message.
Note: This product is for cord and cordless use.
21

Publicidad

Tabla de contenido
loading

Tabla de contenido