Cross Blades - Magic Bullet MBR10 Manual De Instrucciones

• Do not remove the rubber
or plastic liners inside the
motor base.
• Use a sponge or dish cloth
dampened with warm soapy
water to wipe down the inside
and outside of the motor base
until clean.
• Pay particular attention to the
actuator tabs on the inside
of the motor base to loosen
any stuck or sticky debris from
drips and spills. If necessary
you may use a small brush to
scrub the area to ensure it is
kept clean.
13

CROSS BLADES:

Do not remove the gasket as this
may permanently damage the
cross blade and cause leakage.
• Dry the cross blades
completely. It is helpful to turn
the blade on its side in your
dish drainer to ensure
SIDES
of the cross blade are
completely dried.
• We recommend replacing
your Magic Bullet
every 6 months or as needed
for optimal performance.
BOTH
cross blade
®