Etac Ki Mobility AXIOM AS Manual De Instrucciones página 11

C. Cleaning (Continued)
3. Sanitizing the Foam Base
NOTE: Do not immerse your foam base in any solution.
a. Fill a spray bottle with a 70% or greater alcohol solution.
b. Remove the fluid bladders and reservoir plugs.
c. Lay the foam base in the bathtub or on a surface that can get wet.
d. Spray the entire surface of the foam base including the sides. Flip it over and repeat
on the bottom. Once you've finished spraying, let the solution set for 20 to 30 min-
utes.
e. Wipe the solution off with a damp wash cloth. Do not spray with water.
f. Allow the material to air dry but avoid direct sunlight. Depending on how wet your
foam base is, it may take 24 hours to several days to completely dry. Verify that no
solution remains in the foam base before using.
4. Cleaning or Deodorizing Fluid Pads
NOTE: Never immerse the fluid pads in any solution. Never clean with abrasive
materials.
a. Remove the cover from the foam base.
b. Remove fluid pads from the inner cover.
c. Fill a spray bottle with detergent or deodorizer. Verify that the labeling for the manu-
facturer of the detergent or deodorizer indicates that it is appropriate for this use.
Follow the manufacturer's labeling for proper solution concentration and use.
d. Spray and wipe the bladders with a clean dry cloth.
e. Make sure the bladders are completely dry before reassembly.
10