Gordon Ellis & CO Derby 6070 Guia De Inicio Rapido

Derby Elephant Feet
Furniture Raisers
Welcome to your new Gordon Ellis product.
We hope that it is a useful aid to your daily life.
This product was specifically developed by our UK design team and is intended
to compensate for an injury or overcome a temporary or permanent disability.
Please read the user instructions below carefully, and retain them for future
reference.
About this Product
Fitting Instructions
1. Ensure the non-slip pads are in place on top of the Elephant Feet.
2. Place two Elephant Feet close to the existing feet of the piece of furniture.
3. Carefully lift on to the Elephant Feet. Be careful not to strain yourself when
lifting
4. Repeat at the other side of the piece of furniture.
5. Ensure that each leg is centred on the Elephant Feet. Test for stability.
6. If the furniture is moved, ensure that it is secure by repeating the above
instructions
Caution
Only use Elephant Feet under static furniture.
Avoid knocking into the furniture as it might become dislodged and fall.
If knocked check to ensure stability.
Always raise all the legs or feet of the furniture and by the same height as raising
unevenly may strain the structure of the furniture.
Do not use on uneven surfaces.
Cleaning Instructions – wipe down with clean soapy water
6070
Derby Elephant Feet are designed to raise the height
of chairs, beds or tables by 9-cm (3½'') or 14-cm
(5½'') depending on model. Elephant Feet will accept
leg diameters of up to 8.5 cm.
6074
Maximum load:
60 stone, 380 kg, 840 lbs
Part number:
6070, 6074
Made in UK
Registered Design
Gordon Ellis & Co
Trent Lane
Castle Donington
Derby DE74 2PY
England
Tel: (01332) 810504
Fax: (01332) 850830
enquiries@gordonellis.co.uk
www.gordonellis.com
Company registered in England
No. 231734
VAT No. GB 428 4666 26
60701/1016