HQ-Power VDL80FB Manual Del Usuario página 3

• Do not use the device if the ambient temperature exceeds 45°C. The max. temperature for the housing
is 130°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by
unqualified people. Any damage that may occur will probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short-circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
4. Installation
a) Installing or Replacing a Lamp
CAUTION: Only install a lamp when the device is unplugged from the mains and replace it if it has been
damaged in any way.
• The lamps can become extremely hot during operation, so you should let them cool down for at least
10 minutes before replacing them
• Do not touch the halogen bulbs with your bare hands. Use a cloth to handle the lamps during insertion
and removal.
• Do not install lamps with a higher wattage as they generate higher temperatures than those for which
the device is designed.
• Use two lamps (230V/40W) with an E12 socket.
Procedure
1. Unscrew the top of the housing where you will find the half ball with the coloured lenses.
2. Gently remove the half ball.
3. Remove the old lamp and insert the new one.
4. Carefully reposition the half ball.
5. Fasten the cover.
Note: Do not operate the device with an open cover!!
b) Mounting the Device
Remark: Please consider the contents of EN 60598-2-17 and your own national norms during installation.
A qualified technician should carry out the installation!
• The supporting structure for the device must be able to carry 10 times the required weight for one hour
without deformation of that structure.
• The installation must always be secured by a secondary safety attachment e.g. a safety cable (VDLSC7
or VDLSC8).
• Do not stand directly below the device when mounting, removing or servicing it. Have a qualified
technician check the installation once a year and once before you bring the device into service.
Procedure
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Make sure there is no flammable material within a 50cm radius of the device.
• A qualified electrician should carry out the electric connection.
• Connect the device to the mains with the power plug. In general, lighting effects should not be
connected to dimming packs. Put the power switch in the ON position. The device will produce colourful
light beams at a steady pace.
• The installation has to be approved by an expert before the device is taken into service.
05.05.2010
VDL80FB
3
Rev. 01
©Velleman nv