Step 2 - Prepare Dual-Drawer Refrigerator; Step 3 - Install Dual-Drawer Refrigerator - Haier DD410RS Instrucciones De Instalación Y Manual Del Usuario

INSTALLATION INSTRUCTIONS

STEP 2 - PREPARE DUAL-DRAWER REFRIGERATOR

1. Pull open the upper drawer. Remove the crisper bins and set aside.
2. Using two hands, lift up on the metal drawer divider rod to remove it from
the slots in the front and rear of the drawer.
3. Once the drawer divider rod is out of the slots, turn the rod so that it is at
an angle to the front of the drawer. Lift the rod slowly out of the drawer
to avoid bumping into the control panel, and then set aside the divider
assembly.
4. Close the upper drawer to avoid damage during installation.

STEP 3 - INSTALL DUAL-DRAWER REFRIGERATOR

Depending on the material of your countertop, use either Method 1 - Install
to Countertop or Method 2- Install to Adjacent Cabinet to secure your dual-
drawer refrigerator.
Do not use dual-drawer refrigerator until completely installed.
Do not push down on open drawer.
Failure to follow these instructions can result in serious injury or cuts.
METHOD 1 - INSTALL TO COUNTERTOP
Attach the Anti-Tip Brackets
1. Pry hole covers from the top of the
refrigerator cabinet to reveal the
holes used to install the anti-tip
brackets.
2. Open the upper drawer and leave it
open to install the anti-tip brackets.
3. Remove the anti-tip brackets and
screws from the accessory bag.
4. With the screws provided, fasten the anti-tip brackets to both sides of
the top of the cabinet.
10
WARNING
Tip Over Hazard
Screw
Anti-Tip
Bracket
49-60810