Use Of The Powerpack As 12V Power Source - Waeco PowerPack PS200 Instrucciones De Uso

PS-200-12_q6 16.11.2005
– To switch the safety relay (in the PowerPack) the car-battery has to show a min.
voltage of about 2 volt.
– Ensure when connecting the terminals that no moveable motor parts (fans, cone belts,
generators, etc.) are in the proximity.
Connection of the PowerPack
– First connect the red (+, positive) clamp to the plus terminal of the battery (see C 1).
– Then connect the black (-, negative) clamp to the minus terminal of the battery (see C 2).
If the clamps are connected correctly, the LED "jumping" will light up green (see C 3). In
case of wrong polarity, the LED "jumping" will start flashing red and a signal tone is emit-
ted (see C 4).
– Wait about 5 min. for the flat battery to be charged.
– Start the engine.
– If the engine works, first disconnect the black clamp from the battery terminals, then
the red one.
Caution! Pay attention to any moving parts. Risk of injury.
When using the PowerPack as 12 V power source, observe the following
safety instructions:
– Max. current consumption of connected appliances is 5A.
– Use the 12 V cable which is delivered with the item you want to connect to
the PowerPack. One side of the connecting cable must have a plug, which
fits into the cigarette lighter socket of the PowerPack.
In the case of overcharging the automatic fuse, installed in the PowerPack, will
be activated.
– Switch off the appliance that is to be supplied with 12 V.
– Pull the plug from the cigarette lighter socket and wait approx. 2 minutes.
– The overcharging fuse restarts automatically again.
Operation of the PowerPack (see D)
– Switch off the appliance that is to be supplied with 12 V.
– Put the plug of the connecting cable into the cigarette lighter socket of the
PowerPack.
– Switch on the appliance again.
13:49 Uhr Seite 19
Use of the PowerPack as starting aid

Use of the PowerPack as 12V power source

19