Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of 154.077 (BBP W-DMX
transmitter/receiver).
Set BBP W-DMX transmitter and receiver into operation by connecting its power unit to the power input and the mains plug to a mains outlet (100-240V~,
50/60 Hz). The status indicator shortly flashes red.
Set each fixture to the same DMX frequency. Go to
by colour indication.
As soon as the transmitter receives a DMX signal from the light controller, the status indicator turns red. Shortly thereafter, the status indicators of the
receivers will start flashing green to indicate that the DMX signal is being received. The fixtures can now be controlled via wireless 2.4 GHz DMX signal.
Function once the fixture is switched off:
•
Press the
Functions as soon as the fixture is switched on:
•
Press the
•
Press the
•
Press the
Function as soon as the screen saver is switched on:
•
Press the
1
Red
2
Green
3
Yellow
4
Blue
5
Magenta
6
Cyan
7
White
button briefly to switch the light on
button briefly to change the wireless frequency.
button for 3 seconds to switch off the fixture.
button for 20 seconds to reset factory settings
button briefly to exit screen saver and unlock the menu buttons.
and select the desired universal, it will be displayed
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
1 ~ 512
Publicidad
