9. Insert a wall anchor in each hole, ensuring the
anchor is flush with the wall surface. (See Figure 9)
NOTE: This step may require a light tap with
hammer.
Figure 9
10. Place wall receiver over screw holes and attach
using supplied screws. (See Figure 10)
Figure 10
CAP FITTING AND REMOVAL
FITTING
1.
Slide the cap on using a downward motion.
(See Figure 11)
Figure 11
PAGE 3 OF 9
INSTALLATION CONTINUED
2. Snap the locking tabs in place. If necessary, press in
REMOVAL
1.
2. Slide the cap away from wall to remove.
Cap
1-800-295-5510
uline.com
from the sides to locate the tabs. (See Figure 12)
NOTE: Press in from the side to correctly seat
locking tab.
Figure 12
Locking
Tab
Insert flathead screwdriver or other implement
between the cap and housing. Twist to release the
locking tabs from the catch on each side.
(See Figure 13)
Figure 13
(See Figure 14)
Figure 14
Cap
0422 IH-5098