Care And Maintenance - Tokai TB-210 Manual De Instrucciones

Carrying for Compact Discs
1. Treat the disc carefully. Handle the disc only by its
edges. Never allow your fingers to come in contact
with the shiny,
unprinted side of
the disc.
2. Do not attach adhesive tape, stickers, etc. to the
disc label.
3. Clean the discs periodically with a soft, lint-free,
dry cloth. Never use detergents or abrasive
cleaners to clean the disc. If necessary, use a CD
cleaning kit. If a disc skips or gets stuck on a
section of the disc, it is probably dirty or dam-aged
(scratched). When cleaning the disc, wipe in
straight lines from the center of the disc to the
outer edge of the disc. Never wipe in circular
motions.
4. This unit is designed to play discs bearing the
identification logo as shown here or MP3 format
Disc. Other discs may not conform to the CD
standard and may not play properly.
5. Discs should be stored in their cases after each use
to avoid damage.
All manuals and user guides at all-guides.com

CARE AND MAINTENANCE

24
6. Do not expose discs to direct sunlight, high
humidity, high temperatures,
Prolonged exposure or extreme temperatures can
warp the disc.
7. Do not stick or write anything on either side of the
disc. Sharp writing instruments or the ink may
damage the surface.
To Clean the Lens
The lens of the CD player should never be touched!
If the lens gets dirty, your player may skip or may not
play a CD.
Sudden changes in the surrounding temperature can
cause condensation on the lens of your CD player.
Playing a CD is then not possible. Do not attempt to
clean the lens but leave the set in a warm environment
until the moisture evaporates.
Always close the CD door to keep the CD compartment
dust-free. To clean, dust the compartment with a soft
dry cloth.
1. Open the CD door.
2. Use a camera lens blower/brush to blow on the
lens once or twice, brush the dust or particles off
the lens then blow again.
3. To remove fingerprints, use a dry cotton swab to
wipe from the middle to outer edge of the lens.
Care of the Cabinet
1. To prevent fire or shock hazard, disconnect your
unit from the AC power source when cleaning.
2. The finish on your unit may be cleaned with a dust
cloth and cared for as other furniture. Use caution
when cleaning and wiping the plastic parts.
3. Mild soap and a damp cloth may be used on the
front panel. Do not use any cleaning agents
containing alcohol, ammoniac, benzene or
abrasives as these may harm the housing.
or dust, etc.