Care And Service; Optional Accessories - Kärcher KWD 1 Manual De Instrucciones

Inserting the filter bag
1. Fully unfold the filter bag.
2. Attach the filter bag to the device connection and
press it on firmly.
Illustration D
3. Fit and lock the device head.
Illustration E
Note
We recommend using a filter bag to vacuum fine dust.
Accessory application
1. Connect the suction hose.
Illustration F
2. Install the floor nozzle.
 Install the insert in the floor nozzle.
 Connect the floor nozzle to the suction tubes.
Illustration G
Starting up the device
1. Plug the mains plug into the socket.
Illustration H
2. Set the trigger into the desired position.
Illustration I
 Position "1 ON": The suction / blowing function is
activated.
 Position "0 OFF": The device is switched off.
Note
Limited for Switzerland only: The socket outlet shall on-
ly be used during operation in dry condition.
Operation
Note
Pay attention to the latest part numbers when purchas-
ing and installing filter bags and cartridge filters.
Information on accessories and spare parts can be
found at www.kaercher.com.
Dry vacuuming
ATTENTION
Vacuuming cold ashes
Device damage
Only vacuum cold ash with an ash pre-separator.
ATTENTION
Defective or wet foam filter / cartridge filter
Device damage
Before starting up, check the foam filter / cartridge filter
for damage, and replace it if necessary. Only vacuum
with a dry foam filter / cartridge filter.
Depending on the equipment variant, a foam filter or a
cartridge filter is included.
 For devices with a foam filter: Always use the filter bag
in addition to the foam filter when dry vacuuming.
 For devices with a cartridge filter: Always use the fil-
ter bag in addition to the cartridge filter when vacu-
uming fine dust.
Note
Replace the filter bag in good time, as a filter bag that is
too full could be damaged. The fill degree of the filter
bag depends on the amount of dirt vacuumed. The filter
bag should be replaced more frequently when vacuum-
ing fine dust, sand, etc.
Wet vacuuming
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag when vacuuming wet.
8
ATTENTION
Operation with full container
When the container is full, a float switch closes the suction
opening and the device runs at a higher speed.
Switch off the device immediately and empty the container.
Note
If the device falls over, the float can also close. To make the
device capable of vacuuming again, set up the device,
switch it off, wait 5 seconds and then switch it on again.
The blower function can be used to clean areas that are
difficult to reach or where vacuuming is not possible,
e.g. leaves in a gravel bed.
 Insert the suction hose into the blower connection.
The blower function is now activated.
Illustration J
Interrupting operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Place the handle of the suction hose in the interme-
diate parking position.
Illustration K
1. Set the trigger to "0 OFF".
The device is switched off.
2. Pull out the mains plug.
3. Remove the device head.
Illustration B
4. Empty the container.
Illustration L
5. Store the device in a dry and frost-proof room.

Care and service

General care instructions
 Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
 Rinse the container and accessories with water, as
necessary, and dry them before further use.
Clean the foam filter / cartridge filter
1. If necessary, the foam filter / cartridge filter can be
cleaned under running water. To do this, remove the
foam filter from the filter basket. The cartridge filter
can be unlocked and removed by turning it towards
the symbol
2. Do not rub or scrub the foam filter / cartridge filter
when cleaning it.
3. Allow the foam filter / cartridge filter to dry complete-
ly before using it again.
4. Depending on the filter type, reinsert as follows:
 Foam filter: Pull the filter over the filter basket and
ensure that it is fixed correctly.
 Cartridge filter: Install the filter on the filter basket,
turn it towards the symbol
is fixed correctly.
Illustration M
Illustration N

Optional accessories

Note
For variants with a foam filter, a cartridge filter can be
purchased later as a special accessory and used in-
stead of the foam filter.
1. Before inserting the cartridge filter, remove the black
cover cap and keep it with the foam filter for later use.
English
Blower function
Ending operation
.
and ensure that it