Installing The Device; Selecting The Installation Location; Connecting The Device To The Gas Supply - Dometic CVH1350GOG Instructions De Montage Et De Service

CVH 1350GOG, CVH 1525GOG, CVH 1700GOG
7

Installing the device

The assembly and installation of the gas connection must be performed
by a qualified person who has demonstrated skill and knowledge related
to the construction, installation and operation of gas appliances and has
received safety training to identify and avoid the hazards involved.
7.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
• There must be air vents with a cross-section of at least 150 cm
location.
• Make sure that the minimum distances (fig. 2, page 4) are observed.
• Ensure that there are no drafts at the installation location.
7.2 Installations steps
1. Create a cutout in the countertop (fig. 3, page 5).
2. Attach a rubber seal between the countertop and the device.
I
NOTE
Contact the manufacturer if the device is not supplied with a rubber seal.
3. Fasten the device in the countertop (fig. 4, page 6).
7.3

Connecting the device to the gas supply

The assembly and installation of the gas connection must be performed
by a qualified person who has demonstrated skill and knowledge related
to the construction, installation and operation of gas appliances and has
received safety training to identify and avoid the hazards involved.
!
WARNING! Explosion hazard
• Only use propane or butane gas containers with a certified pressure
reduction valve and suitable head.
• Compare the pressure information on the data plate with the pres-
sure information on the propane or butane gas containers.
• Avoid any stress on the gas pipe system during and after installation.
EN
Installing the device
2
in the installation
21