Accessories; Function - Windgoo B20 Manual De Instrucciones

Folding
Product accessories
Function Introduction:
1. Charging: connect the charger to charge, with AC plug first and DC plug next. When
the power bar on bike handle shows full and the charger indicator turns green from red,
it indicates full power.
2. Press the power button: Push forward the power button to turn on the bike. The dash
board lights up after booting. Push back the power button to turn off the bike. The dash
board light will be off after turning off the power.
3. fter booting, the dash board lights up and indicate the amount of electricity,
4. Front light and rear light: press the red button 3 seconds then release, turn up the
lights. Press the red button 1 seconds to turn off the light.
5. Brake light: Back light lights up when braking. It could not accelerate before the
brake is fully loosened.
6. To start the scooter, first slide the scooter with your foot 1-2 meters, then press the
accelerator for running，then use your feet to get up to 5km/h and then use the throttle
to accelerate. Press the throttle lightly to accelerate the vehicle, and press it harder the
speed goes faster. The dash board will show the speed per hour.
7. Speeding : Please speed up slowly, don't force the rotating bar hard or it will be
broken.
8. Cruise: Press the green button when ride, then the bike runs at the same speed.
Press the button again and brake or release the rotating bar and speed up again then
the cruise mode is canceled.
9. Driving mode: The bike has electric driving mode and chains driving mode. Turning
on the power and rotating acceleration bar, the bike will work at electric driving mode.
Without power, the bike will work with pedal at chains driving mode.
05