FONESTAR FDT-112 Manual De Instrucciones página 3

CONNECTION
- Before making any connections, make sure that all the devices in the audio system are switched off.
- Select the operating mode, mono or stereo, depending on how the splitter is going to be used.
- If the mono mode is selected, connect the audio input signal to the CH 1 (MONO) INPUT. In this case, up
to 10 mono outputs can be used.
- If the stereo mode is selected, connect the audio input signal to the inputs CH 1 (MONO) INPUT and CH 2
INPUT. In this case, up to 5 stereo outputs can be used.
- If you wish to connect several devices in cascade, the OUTPUT LINK can be used to connect it to the input
of the next device.
- Power the device using the AC power supply socket.
- Once the connections have been made according to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the mains supply.
Below are two different connection examples depending on the splitter operating mode:
Mono mode
Stereo mode
- 3 -
EN