Adjusting The Lens Focus - Honeywell HD4VC4HR Guia Del Usuario

Figure 5 Gimbal Adjustment
Top view
Locking screw. Loosen to
adjust Horizontal (B).
Set focus
Set focal length

Adjusting the Lens Focus

Lenses are pre-focused at the factory but may require a final adjustment after installation in
the unlikely event the optical effect of the dome causes a slight defocusing of the lens.
TECH TIP! To check the focus, hold the dome over the lens while making any
adjustments.
To adjust the camera direction, view angle and focus, connect the service monitor cable
(supplied) to the video monitor output.
Rev 1.02
Locking
screw
Dip switches
8
Angle view
Setscrews (x2). Loosen to
adjust Pan (C). Other setscrew
located on opposite side.
B
C
Legend:
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
A
Document 900.0556
01/06