Safety Instructions; Machine Information - VONROC WL507AC Manual De Instrucciones Traducido

EN

1. SAFETY INSTRUCTIONS

Read the enclosed safety warnings, the additional
safety warnings and the instructions. Failure to
follow the safety warnings and the instructions may
result in electric shock, fire and/or serious injury.
Save the safety warnings and the instructions for
future reference.
The following symbols are used in the user manual
or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-obser-
vance of the instructions in this manual.
Risk of electric shock.
Not suitable for applications with external
dimmers.
Minimal distance between the light source
and illuminated objects.
Protection class IP65.
Replace damaged glass covers.
Do not dispose of the product in unsuitable
containers.
The product is in accordance with the
applicable safety standards in the European
directives.
SAFETY WARNINGS FOR WORK LIGHT
a) Please read and observe all safety warnings
and instructions enclosed with the flood light.
b) Do not use the flood light in hazardous areas.
c) Do not direct the light beam at persons or
animals and do not stare into the light beam
yourself (not even from a distance).
d) Do not cover off the lens while operating the
flood light. The flood light heats up during
operation and can cause burns when the heat is
allowed to accumulate.
e) Do not allow children to use the flood light. It is
intended for professional use. Children can un-
intentionally blind themselves or other persons.
4
2. ASSEMBLY
Place the tripod stand (Fig. B-1, B-2)
1) Loosen the locking screw (6).
2) Fully extend the tripod legs (7).
3) Re-tighten the locking screw (6).
4) Place the tripod stand on a stable, level surface.
The tripod legs (7) must always be fully
extended to ensure the stability of the
tripod and prevent the flood light from
tipping over / falling. To adjust the height
of the tripod stand, do not (partially) retract
the tripod legs. See the paragraph
'Operation / Adjustment' below for the
correct height adjustment procedure.
Install the support bar (Fig. C)
1) Position the support bar (4) on top of the tripod
stand. Align the center hole of the support bar
with the tripod stand.
2) Fix the support bar (4) in place by installing
a locking screw (3) through the center hole.
Install the lights (Fig D-1, D-2)
1) Position a light (1) on both ends of the support
bar (4). Align the hole in the light brackets with
the hole on each end of the support bar.
2) Fix the lights (1) in place by installing a locking
screw (3) through the hole in the light brackets.
3) Attach the cable splitter (8) to the support bar
(4) using the screw (9).

3. MACHINE INFORMATION

Intended use
The twin flood light is intended as mobile illumi-
nation for temporary use and is not suitable for
permanent room lighting.
TECHNICAL SPECIFICATIONS
Model No.
Input
Power
Luminous flux
Beam angle
Weight
Height
WL507AC
220-240V~ 50Hz
2x 20W (40W total)
2x 1600lm (3200lm total)
100
o
2kg
80-126cm
WWW.VONROC.COM