Operation - Kärcher SC 2.500 C Manual De Instrucciones

Operation

 Illustrations on fold-out
page 3!
Attaching the Accessories
 Illustration
Insert steering roller and transport
wheels and lock them.
 Illustration +
Connect the required accessories (see
Chapter "Using accessories) to the steam
gun. Insert the open end of the accessory
on the steam gun and push onto the
steam gun until the unlocking button of
the steam gun locks into place.
 Illustration
Use the extension pieces if necessary.
To do so, connect one or both exten-
sion pieces to the steam gun. Insert the
required accessories on the free end of
the extension piece.
Removing the Accessories
Danger
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
 Move the selector switch for the steam
volume back (steam lever locked).
 Illustration
To detach the accessory parts, press
the unlocking button and pull the items
apart.
Filling the Water Reservoir
The water reservoir may be refilled at any
time.
Caution
Do not use condensation water from the drier!
Do not fill in detergents or other additives!
 Illustration
You can remove the water reservoir to fill it
or you can fill it directly on the appliance.
Take off water reservoir.
 Pull the water reservoir straight up.
 Fill the water reservoir up to the "MAX"
marking while positioned vertically un-
der the water tap.
16
All manuals and user guides at all-guides.com
 Insert the water reservoir and press
Directly on the appliance
 Pour water from a container into the fun-
 Place the unit securely on a firm surface.
 Insert the mains plug into a socket.
 Press the ON switch to turn on the ap-
Note: If there is no or not enough water in
the steam boiler, the water pump starts and
supplies water from the reservoir into the
steam boiler. The filling process may take
several minutes.
 Wait until the indicator lamp (heater)
The steam cleaner is ready to use.
Refilling Water
In case of water shortage, the indicator
lamp "water shortage" glows red in the wa-
ter reservoir and a signal canb e heard.
 Fill the water reservoir up to the "MAX"
Note: The water pump tries to fill the steam
boiler in short intervals. If the filling process is
successful, the red indicator lamp goes off.
Use the selector switch for the steam vol-
ume to regulate the discharged steam. The
selector switch has three positions:
 Set selector switch to the required
 While operating the steam switch, always
– 8
EN
downwards until it arrests.
nel inlet. Fill up to the "MAX" marking.
Turning on the Appliance
pliance.
lights up permanently.
marking.
Adjusting the Steam Quantity
Maximum steam volume
Reduced steam volume
No steam - child protection
Note: In this lever position, the steam
lever cannot be used.
steam volume.
direct the steam gun at a separate piece
of cloth until the steam is emitted evenly.
Note: The heating of the steam cleaner
is turned on in regular intervals during
the operation of the appliance in order
to maintain the pressure in the boiler at