Sears Kenmore 116.29319 Manual De Uso página 17

Always follow all safety precautions when performing maintenance on the PowerMate ® .
WARNING
Electrical Shock Or Personal Injury Hazard.
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn
PowerMate ®
upside down.
2. Unscrew two (2)
PowerMate ® cover
screws.
3Turn
PowerMate ® right
side up. Press
handle release _x__ ......
the swivel. Lift
rear and side Side Rear
latches up. Latch Latches
4. To remove covert
grasp the sides and
pull out.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and clean end cap areas. See TO
CLEAN AGITATOR (page 18) section and
AGITATOR ASSEMBLY (page 18) illustration
for picture of complete agitator assembly.
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path.
Agitator End Cap
NOTE: See PARTS
AND FEATURES
(page 5) for Belt
number.
2. Piece agitator
assembly back
into PowerMate ®.
3. Line up front
of cover and
base. Rest
cover on front
edge of base as
shown.
Cover Base
4. Rotate cover
,, ;;-_,-,_-Sback. Press cover
" '-::_'_! ..... -_ firmly until side
'-_:_;_;' and rear latches
snap into place.
Latch Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMate ® upside down and re-
place two (2) cover screws.
=17=