EN
KEY FEATURES:
• 3 styling tools in 1: Bubble wand for beach curls/
chopstick wand for corkscrew curls/ 25-19mm wand for
natural waves
• Fast heat-up to 210°C in only 30 seconds
• Keratin + Argan infused ceramic attachments for
smoother, shinier results
• Consistent heat spread leaves curls naturally defined
• Cool tip for steady grip
• Includes heat protective glove for comfortable, easy
curling
• 3m salon length heat resistant swivel cord
• Multi-voltage for worldwide use
• UK/EU plug adaptor for travel
OPERATING INSTRUCTIONS:
Connecting attachments to the Multi Styler:
• Always ensure the Multi Styler is cool and unplugged
from the mains supply when connecting and disconnecting
attachments
• To connect attachment
• Turn base lock to OPEN and align the attachment to the
base matching the ARROW symbols. Firmly press the
attachment down so the attachment base meets the base
lock. Turn the base lock into the LOCK position until it
cannot be turned anymore.
• To remove attachment
• Turn the base lock into the OPEN position. Firmly pull
the attachment away from the base lock.
Using the Multi Styler:
• Before using the Multi Styler, comb through hair to
remove any tangles
• Ensure hair is clean and fully dry
• Connect attachment and plug in to mains supply
• Switch Multi Styler On by sliding the On/Off button
upwards into the ON position. The red indicator light will
glow red. The Multi Styler will begin to quickly heat-up.
After 30-40 seconds the Multi Styler is ready for use.
• Switch the Multi Styler Off by sliding the On/Off button
downwards into the OFF position. Unplug the Multi Styler.
Rest on a heat resistant surface and allow to fully cool
before dismantling the attachments
INSTRUCTIONS FOR USE:
Using the Multi Styler:
3 tools in 1
• Bubble wand – for loose, tousled beach waves
• Chopstick wand – for spiral, corkscrew curls
• 25mm to 19mm wand – for natural waves and curls
• Ensure hair is fully dry and tangle free
• Connect the desired attachment as described in
Connecting Attachments to the Multi Styler
• Switch the Multi Styler On
• Take a section of hair and slowly wind around the barrel
aiming the barrel downwards
• Hold the hair in place for 10 seconds, resting your finger
on the cool tip
• Slowly unravel the hair from the barrel to produce a
beautiful curl. Allow the hair to cool before further styling
in order to set the wave
• For loose waves, wrap larger sections of hair around the
barrel
• For tighter curls wrap smaller sections of hair around
the barrel
• For extra volume brush through the waves or curls
• Set the style with a mist of hairspray
CLEANING AND MAINTENANCE:
Make sure the unit is cool, switched off and unplugged.
The Multi Styler may be wiped with dry, lint-free cloth.
Attachments can be cleaned with a damp cloth and
should be allowed to dry overnight before using again.
IMPORTANT INSTRUCTIONS:
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE
INSTALLATION OF A RESIDUAL CURRENT DEVICE (RCD)
WITH A RATED RESIDUAL OPERATING CURRENT NOT
EXCEEDING 30mA
IS ADVISABLE. ASK AN ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN
INTO A BATHROOM, IT SHOULD NOT BE USED
NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR
OTHER LIQUIDS. This product is not suitable for
use in the bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS
SUPPLY WHEN NOT IN USE.
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding,
towels, rugs etc.
Always ensure the voltage to be used corresponds to the
voltage stated on the unit.
Keep this product out of reach of children. The use of this
appliance by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their
safety should give explicit instructions or supervise the
use of the appliance.
Do not use any attachments with this styler, other than
those supplied by Trevor Sorbie.
Avoid allowing any part of the hot barrel to contact the
face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly
for any sign of damage.