Connecting To Wifi - ProBreeze PB-15 Manual De Instrucciones

Display
•
As a default, the LED display will show
the RH (relative humidity) of the room to
+/- 5%accuracy.
•
If there is a problem with the unit, the
following will display:
• P2: water tank is full or not in the
right position. Empty the water tank
or check its positioning.
• AP: device is in auto-pairing
mode, which is used to connect
to wifi. This mode should turn off
automatically within 8 minutes.
• AS: humidity sensor error. Unplug
the unit, wait 30 seconds and plug
back in. If the problem persists,
contact support.
• ES: tube temperature sensor error.
Unplug the unit, wait 30 seconds
and plug back in. If the problem
persists, contact support.
7 | English

CONNECTING TO WIFI

― ―
Note: if you are having issues connecting
to Wifi, please ensure your network is set to
2.4G. If you are continuing to have issues,
please contact our customer care team by
emailing help@probreeze.com
• To connect to WiFi, hold the filter button
down for 3 seconds, or until the LED
display shows "AP" (auto-pairing). When
in auto-pairing, the compressor will be
forced off.
• Ensure the dehumidifier and your mobile
are connected to the same WiFi.
• Download the "NetHome plus" app.
You will have to create an account.
On screen, select "add device" and
then select "dehumidifier". Follow the
instructions on the app.
• When the connection is successful,
the dehumidifier will automatically turn
back on.
• If after 8 minutes the connection is
unsuccessful, the dehumidifier will
automatically turn back on. Start the
connection process from the beginning.
• Once connected, you can view
performance and control your
dehumidifier through the app.