Uline H-9637 Manual Del Usuario página 3

8. Fasten tabletop to mounting plates with six wood
screws using a Phillips screwdriver or 10 mm wrench.
(See Figure 5)
NOTE: For additional security, attach two remaining
wood screws to side panel mounting plate.
(See Figure 5)
9. Using a 10 mm wrench, attach front panel shelf
mount to front panel on each end and in center by
inserting one M6 x 30 mm hex bolt and one
M6 flat washer into threaded nut. (See Figure 5)
NOTE: Place at same height as back panel
shelf mount.
NOTE: Workbench shown without tabletop.
Figure 5
Mounting
Plates
Front Panel
Shelf Mount
10. Insert the bottom shelf panels. They should sit on the
lower shelf lip. (See Figure 6)
11. Insert the center shelf panels with the cut sections
facing the back left, back right and center corners
of the cabinet. (See Figure 6)
Figure 6
Shelf Panels
PAGE 3 OF 24
ASSEMBLY CONTINUED
Side Panel
Mounting Plate
Center
Shelf Panels
Bottom
12. Disassemble door handle. Reassemble door handle
with lock bar. Repeat for other door. (See Figure 7)
Figure 7
13. Position upright on back corner of tabletop.
The upright mounting plate should be positioned
directly over the previously drilled holes. Insert four
M6 x 70 mm bolts and M6 washers through uprights,
tabletop and workstation frame. Using 10 mm wrench,
secure with M6 flange nuts on underside of table.
Repeat for additional upright. (See Figure 8)
Figure 8
Upright
Lock Bar
Upright
M6 x 70
mm Bolt
Washer
Mounting
Plate
Flange Nut
Leg
0322 IH-9637