Publicidad
Idiomas disponibles
Idiomas disponibles
English
Anti-skate Adjustment
• A small outward "anti-skating" force can be applied to the tone arm to compensate
for the "skating" force that pulls the arm toward the center of the record.
• For best performance during normal turntable usage, it is recommended to set the
anti-skate control knob to the same value as indicated by the downforce scale dial.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent damage
to the stylus during the replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then
remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely
tighten the screws at this moment.
5. Connect the wire leads to the new cartridge's terminals .The wire lead color codes
are as below:
White
Left channel positive
Black
Left channel negative
Red
Right channel positive
Black
Right channel negative
6. Adjust the cartridge's position to make sure it is precisely aligned on the headshell
so that the stylus will be tracking the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the
turntable spindle, carefully lift the tone arm and place the tip of the stylus on the
points marked 130mm and 250mm respectively. Fine tune the cartridge's position
on the headshell until the cartridge is perfectly in parallel with the reference lines at
both points.
7. Tighten the screws completely once the perfect alignment is achieved.
Bluetooth Output Operation
This turntable features Bluetooth output which is a device that transmits audio from
this turntable to another Bluetooth device such as wireless Bluetooth headphones,
Bluetooth speakers, or other Bluetooth receiving devices.
1. Place the audio device that supports Bluetooth technology as close to your
turntable as possible.
2. Set the turntable's function switch to the ON position for Bluetooth output.
Note: The function indicator will slowly flash blue.
3. Set the device that you would like to connect to pairing mode.
(L+)
(L–)
(R+)
(R-)
7
Publicidad
