Publicidad
Idiomas disponibles
Idiomas disponibles
2610067140 3Z Laser Measurer 02-21.qxp_Layout 1 2/24/21 8:01 AM Page 1
Area Measurement
– Press the measuring button (1) twice in quick succession to multiply the
last two measurements together. The indicator (f)
display and the area measurement is shown.
– Switch on the measuring tool (see "Switching the laser measure on/off",
page 12).
Measuring Length (see figures 8−10)
– Run the wheel (13) along the distance to be measured. After the meas-
uring tool has been switched on, the wheel measures continuously. The
current measured value (a) is shown on the bottom line of the display.
During continuous measurement, the wheel can be moved forwards or
backwards. The measured values will be positive in both directions. If
the direction is changed during the measurement, the value will be de-
ducted until the starting point (zero point) has been reached. Once the
starting point has been crossed, the value will become positive again.
The current measured value (a) is updated on the bottom line of the dis-
play.
– The measuring process ends once the wheel has come to a stop. The
current measured value (a) is shown.
– Press the measuring button (1) again to save the measured value, and
continue measuring. The current measured value (a) is shown on the
bottom line of the display, while the previous measured value (b) is dis-
played above it.
Note: In order to obtain an exact measurement, do not change the angle
between the measuring tool and the surface (see figure 10). Make sure that
you apply a steady amount of pressure throughout the measuring process.
The result may vary on soft substrates and/or when applying excessive
pressure. The recommended pressure for an exact measurement result is
1.1 pound-force (500 g).
18
Operation - Wheel Adapter
appears on the
ft
2
Publicidad
