Connecting & Powering Multiple Fixtures In Series; Connecting The Led Fixture To The Mains - Lumatek VF650W Manual

6.4 Connecting & Powering multiple fixtures in series
The VF 650W LED driver can be used to power up to seven VF90W or five VF120W fixtures simultaneously.
Each fixture has a power input cable (male connector) and a power output cable (female connector).
The LED driver power output cable is connected to fixture1 power input cable.
Fixture1 power output cable is connected to Fixture2 power input cable.
Fixture2 power output cable is connected to Fixture3 power input cable and so on until all fixtures
are connected.
Example of horizontal connection plan:
For alternative light plans and greater flexibility, extension connecting cables are available to purchase
separately.
Example of vertical connection plan with extension connecting cables:

6.5 Connecting the LED fixture to the mains

Warning! Make sure mains power is switched off.
Warning! Ensure the power supply cable is not coiled and does not touch any hot surfaces.
Warning! Connect the cables according to local rules, safety regulations and electrical code.
Warning! If not using an external lighting controller ensure external switching gear can cope
with theinrush current of the LED fixture. Always use a timer contactor suitable for switching
a capacitive load. Never use household timers to switch the LED fixture!
Warning! Do not connect or disconnect the LED fixture under load.
Ensure the LED driver power supply cable self-locking female connector is correctly aligned to the
corresponding male connector on driver and push together until click-locked. To disconnect;
turn twist-lock connector anti-clockwise to unlock and pull apart from driver.
Connect mains power plug to switching gear/power supply.
Switch on mains power.